Hubbardton-forge 137650 Manual do Utilizador descarregar pdf

Assembly & Installation Instructions A256

For Current Pendant 13-7650 Page 1 of 3

Hand-Forged, Vermont-Made Lighting and Accessories

P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735

24786

To Install to Ceiling (Figures 1 thru 5)

Component Part

A Ceiling Bracket

B Cable Gripper (2)

C Gripper Nut (2)

D Canopy

E Support Cable (2)

F Fixture

G Supply wire

H Strain Relief

I Washer

J Cupped Washer

K Hex Nut

Caution: Be sure power is off at the main breaker box prior to

installation.

1. Carefully unpack the fixture from the carton.

2. Using two machine screws (not provided),

fasten the ceiling bracket (A) to the electric

box.

Note: A new electric box comes with screws.

When replacing a fixture, retain the existing

screws for use with the new fixture.

3. Slip gripper nuts (C) onto the support cables

(E) and allow to rest on top of fixture (F).

4. Pull support cables (E) and supply wire (G)

through canopy (D) allowing canopy to rest on

top of fixture (F).

5. Raise fixture and push support cables (E)

through cable grippers (B) until desired fixture

height is accomplished and level.

6. Slip supply wire (G) through strain relief (H)

and push supply wire (G) through slot on the

bottom of ceiling bracket (A) followed by

washer (I). Adjust location of strain relief (H)

on supply wire (G) until it will snap into

location provided on ceiling bracket (A).

7. Snap strain relief (H) onto supply wire (G) and

push into tab on ceiling bracket (Figure 3).

8. Once support cables are at the correct height, excess cable can be cut off. To keep the strands of cable together a

small piece of electrical tape can be applied to the cut end.

9. Cut excess supply wire (G) allowing enough left (approx. 6”) to make connections in the electrical box. Strip

outside jacket being careful not to cut through shielding of the two inner conductors.

(continued)

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL

INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.

This product must be installed in accordance with applicable installation code(s), by a person familiar with the

construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 2)

(Figure 1)

1 2 3

A256 1
24786 1

Resumo do Conteúdo

Página 1 - 24786

Assembly & Installation Instructions A256 For Current Pendant 13-7650 Page 1 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O.

Página 2

Assembly & Installation Instructions A256 For Current Pendant 13-7650 Page 2 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O.

Página 3

Assembly & Installation Instructions A256 For Current Pendant 13-7650 Page 3 of 3 Hand-Forged, Vermont-Made Lighting and Accessories P.O.

Comentários a estes Manuais

Sem comentários

Hubbardton-forge 137650 Manual do Utilizador

Consulte online ou descarregue Manual do Utilizador para Iluminação Hubbardton-forge 137650. Hubbardton Forge 137650 User Manual Manual do Utilizador

Resumo do Conteúdo

Comentários a estes Manuais

Manuais e produtos relacionados com Iluminação Hubbardton-forge 137650